07.130.0121: Epoxy Terrazzo – System Overview This detail shows a basic overview of an epoxy terrazzo system. There is a vapor barrier underneath the concrete slab, and the slab is properly prepped and profiled to receive all components of an epoxy terrazzo system. Note: crack isolation membrane may be required, but is not shown. The…
06.130.1302: Floor Tile Expansion Joint – Over Concrete Control Joint This detail shows a tile expansion joint in floor system made up of tile adhered to a concrete subfloor using a dry-set or latex-modified portland cement mortar bond coat. A 1/4″ wide saw cut is made at the existing crack in the concrete to form…
06.130.1301: Floor Tile Expansion Joint This detail shows a tile expansion joint in floor system made up of tile laid in a mortar bed, adhered to the cured mortar bed using a dry-set or latex-modified portland cement mortar bond coat. The mortar bed is reinforced with 2″ x 2″ wire mesh, and an antifracture or…
06.130.1300: Wall And Floor Tile – Thinset, Corner Condition This detail shows tile floor and walls laid using a thin-set method. The tile is adhered to the substrate using a dry-set or latex-modified portland cement mortar bond coat. Expansion joints are provided at every change in plane, i.e. wall-to-wall and wall-to-floor. This detail is based…
06.130.0103: Floor Tile – Tile on mortar bed over plywood This detail illustrates tile laid on a cured reinforced mortar bed over plywood, with a cleavage membrane separating the tile assembly from the substrate. Waterproof or crack isolation membranes are optional, per design. This detail is based on TCNA Method F145.
06.130.0201: Floor Tile – Cement Mortar Bed on Concrete This detail shows tile laid in a mortar bed on concrete. The tile is adhered using a dry-set or latex-modified portland cement mortar bond coat (optional). The sand and cement mortar bed is reinforced with a 2″ x 2″ wire mesh. If required, a waterproof /…
06.070.0104: Wall Tile – Thinset On Concrete Masonry This detail shows tile over concrete masonry (CMU) laid in the thin-set method. The CMU has flush joints. The tile is adhered using a dry-set or latex-modified portland cement mortar bond coat. This detail is based on TCNA Method W202. Dynamic 3D Detail Explore this detail and…
06.070.0103: Wall Tile – Cement Mortar This detail shows tile over concrete laid in cement mortar. There is a waterproof membrane over the backing (if required), metal lath embedded in a scratch coat; then a sand and cement mortar bed, with the tile adhered to a dry-set or latex-modified portland cement mortar bond coat. This…
06.070.0102: Wall Tile – One Coat Method, Non-Wet Area This detail shows tile over concrete masonry (CMU) laid in the one-coat method in a non-wet area. There is metal lath embedded in a bed of mortar, with the tile adhered to a dry-set or latex-modified portland cement mortar bond coat. This detail is based on…
02.120.1501: Wall Intersection Detail