02.610.0201: Injected Foam Insulation
02.610.0201: Injected Foam Insulation
02.610.0201: Injected Foam Insulation
02.410.0142: U-Block CMU Bond Beams
02.010.1302: Control Joint – Grout Fill This detail shows standard CMU being used at the vertical control joint, with vertical grout fill used to key in the block. The building felt breaks the bond at one side of the grout fill, to allow for shrinkage of the block, while providing some resistance to lateral loads.…
02.410.0141: Knock-Out CMU Bond Beams
02.410.0132: High Lift Grouting Procedures This diagram illustrates high lift grouting procedures in the field of the wall. Vertical bars are spaced per structural design and reinforced cells are filled solid with grout. Horizontal bond beams are also spaced per design and can be formed with standard open-cell CMU with cross webs knocked out to…
02.010.1301: Control Joint – Preformed Gasket This detail shows specially shaped sash block being used at the vertical control joint, to allow for insertion of a preformed gasket. The gasket is a rigid material, allowing in-plane shrinkage of the block, while providing some resistance to lateral loads. There is horizontal joint reinforcement at 16″ o.c.…
02.410.0124: Horizontal Joint Reinforcement Tolerance
02.410.0131: Low Lift Grouting Procedures This diagram illustrates low lift grouting procedures in the field of the wall. Vertical bars are spaced per structural design and reinforced cells are filled solid with grout. Horizontal bond beams are also spaced per design, and can be formed with standard open-cell CMU with cross webs knocked out to…
02.410.0123: Reinforcement Placement Tolerance
02.410.0122: Reinforcement Placement Tolerance