07.130.0324: Polyacrylate Terrazzo – Divider Strip Over Saw Cut CJ
07.130.0324: Polyacrylate Terrazzo – Divider Strip Over Saw Cut CJ
07.130.0321: Polyacrylate Terrazzo – Divider Strips & Expansion Joint
07.130.0321: Polyacrylate Terrazzo – Divider Strips & Expansion Joint
07.130.0311: Polyacrylate Terrazzo – System Overview
07.130.0311: Polyacrylate Terrazzo – System Overview
07.130.0211: Sand Cushion Terrazzo – System Overview
07.130.0211: Sand Cushion Terrazzo – System Overview This detail shows a basic overview of a sand cushion terrazzo system. There is a vapor barrier underneath the concrete slab. Isolation membrane separates the cementitious terrazzo from the structural slab. A sand and cement underbed is built up 2 1/2″ to 3″ thick and reinforced with 2″…
07.130.0131: Epoxy Terrazzo – Control Joint Detail
07.130.0131: Epoxy Terrazzo – Control Joint Detail This detail shows a control joint in an epoxy terrazzo floor system, which would occur at a control joint in the concrete slab or at an existing crack in the concrete slab which should be saw-cut to 1/8″ wide prior to installing any terrazzo components. After the moisture…
07.130.0121: Epoxy Terrazzo – System Overview
07.130.0121: Epoxy Terrazzo – System Overview This detail shows a basic overview of an epoxy terrazzo system. There is a vapor barrier underneath the concrete slab, and the slab is properly prepped and profiled to receive all components of an epoxy terrazzo system. Note: crack isolation membrane may be required, but is not shown. The…
06.130.1302: Floor Tile Expansion Joint – Over Concrete Control Joint
06.130.1302: Floor Tile Expansion Joint – Over Concrete Control Joint This detail shows a tile expansion joint in floor system made up of tile adhered to a concrete subfloor using a dry-set or latex-modified portland cement mortar bond coat. A 1/4″ wide saw cut is made at the existing crack in the concrete to form…
06.130.1301: Floor Tile Expansion Joint
06.130.1301: Floor Tile Expansion Joint This detail shows a tile expansion joint in floor system made up of tile laid in a mortar bed, adhered to the cured mortar bed using a dry-set or latex-modified portland cement mortar bond coat. The mortar bed is reinforced with 2″ x 2″ wire mesh, and an antifracture or…
06.130.1300: Wall And Floor Tile – Thinset, Corner Condition
06.130.1300: Wall And Floor Tile – Thinset, Corner Condition This detail shows tile floor and walls laid using a thin-set method. The tile is adhered to the substrate using a dry-set or latex-modified portland cement mortar bond coat. Expansion joints are provided at every change in plane, i.e. wall-to-wall and wall-to-floor. This detail is based…
06.130.0103: Floor Tile – Tile on mortar bed over plywood
06.130.0103: Floor Tile – Tile on mortar bed over plywood This detail illustrates tile laid on a cured reinforced mortar bed over plywood, with a cleavage membrane separating the tile assembly from the substrate. Waterproof or crack isolation membranes are optional, per design. This detail is based on TCNA Method F145.