06.130.0501: Base / cove alternatives This set of diagrams show alterative options to handle the transition of a tile assembly between wall and floor, illustrating a flush cove base, lipped cove base, and simple square base condition. When using a coved base, the horizontal leg of the cove should reside flush or slightly above the…
06.130.0103: Tile Floor, Tile on mortar bed over plywood This detail illustrates tile laid on a cured reinforced mortar bed over plywood, with a cleavage membrane separating the tile assembly from the substrate. Waterproof or crack isolation membranes are optional, per design. This detail is based on TCNA Method F145.
06.410.1311: Expansion Joint Diagram – EJ's at tile perimeter and changes of plane
03.040.0201 – Stone Veneer, Steel Stud Backup
03.030.0401: Anchored stone veneer
03.030.0601 – Stone Veneer, Steel Stud Backup
03.030.0201: Stone Veneer, CMU Backup
03.030.0101 – Flexible flashing, drip edge, termination bar, drainage mat Dynamic 3D Detail
01.030.0804: Brick veneer, CMU backup, rigid insul. w/ taped joints, veneer ties This wall system shows brick veneer, concrete masonry backup, rigid insulation with integral facer and taped joints, and veneer ties tying the brick back to the block. The taped joints in the insulation serve as the wall’s air barrier, per insulation manufacturer’s recommendations.
03.080.0221: Wall System – Adhered Stone Veneer Over Steel Studs Backup, Rigid Insulation, Drainage Material
03.080.0221: Wall System – Adhered Stone Veneer Over Steel Studs Backup, Rigid Insulation, Drainage Material This wall system shows adhered stone veneer on glass mat reinforced gypsum board sheathing on a steel stud backup. The sheathing has a fluid-applied air barrier. Fiberglass insulation resides in the stud cavity, and a full-height drainage mat is outside…