06.130.1300: Wall And Floor Tile – Thinset, Corner Condition

06.130.1300: Wall And Floor Tile – Thinset, Corner Condition This detail shows tile floor and walls laid using a thin-set method. The tile is adhered to the substrate using a dry-set or latex-modified portland cement mortar bond coat. Expansion joints are provided at every change in plane, i.e. wall-to-wall and wall-to-floor. This detail is based…

06.130.0103: Floor Tile – Tile on mortar bed over plywood

06.130.0103: Floor Tile – Tile on mortar bed over plywood This detail illustrates tile laid on a cured reinforced mortar bed over plywood, with a cleavage membrane separating the tile assembly from the substrate.  Waterproof or crack isolation membranes are optional, per design.  This detail is based on TCNA Method F145.

02.010.0312: Base of Wall – Single Wythe Block, Flashing at Inside Face

02.010.0312: Base of Wall – Single Wythe Block, Flashing at Inside Face This detail shows an 8” (nominal) split face concrete masonry (CMU) wall, base of wall condition. There is an interior finish of steel studs and gypsum board, allowing the flashing to return at leaset 8″ vertically and then be anchored to the interior…