06.130.1302: Floor Tile Expansion Joint – Over Concrete Control Joint This detail shows a tile expansion joint in floor system made up of tile adhered to a concrete subfloor using a dry-set or latex-modified portland cement mortar bond coat. A 1/4″ wide saw cut is made at the existing crack in the concrete to form…
06.130.1301: Floor Tile Expansion Joint This detail shows a tile expansion joint in floor system made up of tile laid in a mortar bed, adhered to the cured mortar bed using a dry-set or latex-modified portland cement mortar bond coat. The mortar bed is reinforced with 2″ x 2″ wire mesh, and an antifracture or…
06.130.1300: Wall And Floor Tile – Thinset, Corner Condition This detail shows tile floor and walls laid using a thin-set method. The tile is adhered to the substrate using a dry-set or latex-modified portland cement mortar bond coat. Expansion joints are provided at every change in plane, i.e. wall-to-wall and wall-to-floor. This detail is based…
02.010.0312: Base of Wall – Single Wythe Block, Flashing at Inside Face This detail shows an 8” (nominal) split face concrete masonry (CMU) wall, base of wall condition. There is an interior finish of steel studs and gypsum board, allowing the flashing to return at leaset 8″ vertically and then be anchored to the interior…
04.030.0201: Limestone Anchorage Detail This detail shows one option for anchoring dimension stone to a concrete masonry (CMU) backup using a system of continuous vertical stainless steel struts and horizontal angles with studs welded at top and bottom of the angles for anchorage into kerfs in the stone’s top and bottom edge faces. Dynamic 3D…